Designed by
danekshea
Prints (0)
-
No Prints Yet
Be the first to upload a Print for this Design!
Description
SummaryThis is a bracket for the Mendelmax 2. I recommend printing both in ABS or the bracket in ABS and the shroud in flex ;). I usually super glue them together, I'll get around to making a hinge at some point. I print the fan bracket with support using S3D. If the shroud is to close to the print then just use a few washers to heighten it. Also, be aware of your temperature and fan speed. Too high of a fan speed can influence your temperature too much on some prints. Released through my company Northern Layers: http://northernlayers.com
Design Files
File Size
blowingfanbracket.stl
121 KB
duct.stl
339 KB
blowingfanbracketreinforced.stl
150 KB
Comments