SummaryMounting the HS1177 camera to the plate that came with the BeeRotor was a pain. It required hot glue and after a day of hard racing the camera would detach from the plate. I wanted to make something that would solve this problem. Please note this is a work in progressI only use the higher tilt angle so I don't test on the lower angl. Update: The v2 file works well but where I have my VTX the HS1177 was too far back and making it all a bit tight. So on the v3 I have moved the side 'flanges' back a bit to push the camera body forwards and added a chamfer to the side portion. These two actions move the camera forward enough that it will clear my VTX and give me a few mm more room to work with.Print SettingsPrinter: Wanhao Duplicator i3Rafts: NoSupports: YesResolution: 0.15Infill: 100Notes: Infill doesn't make much difference to time for me so I print at 100%. The overhang on the 'nubs' will probably need support unless your printer can handle a 2mm 90 deg overhang and do it perfectly, otherwise it won't fit into the frame slots.