Designed by
Chaosghoul
Prints (0)
-
No Prints Yet
Be the first to upload a Print for this Design!
Description
SummaryHi Folks, this is a dicetower I designed for the german Pen and Paper DSA. If you don't want the engravings for the stats, just print the "_without_engraving" file, there's also a "_clean" file in which the top of the tower is just flat. The dicetower and dicecatcher are printed in two seperate parts and can be snapped together in a matter of seconds. The tower prints with minimal support (just activate support for the bottom cutout). After the print, snap out the two support beams I put where you throw in the dice. Dicetower and catcher took 48 hours on my Ultimaker 2. Enjoy!
Design Files
File Size
dicetower_new.STL
991 KB
dicetower_without_engraving.STL
160 KB
dicetower_clean.STL
128 KB
dicetower_new_catcher.STL
3.79 KB
Comments