PRINTING INSTRUCTIONS: . Insert balls into sockets with side to side rocking action - pliers recommended. Some sanding might be required depending on your printer. 0.2mm layer height.

• Amelix LEG_armor_upper_front.STL  -print 2x 20%infill, supports needed
• Amelix LEG_armor_upper_back.STL  -print 2x 20%infill, supports needed
• Amelix LEG_armor_lower_front.STL  -print 2x 20%infill, supports needed
• Amelix LEG_armor_lower_back.STL  -print 2x 20%infill, supports needed
• Amelix LEG.STL                                             -print 2x 20%infill, supports included in the model
• Amelix HULL.STL                                          -print 1x 20%infill
• Amelix HIP.STL                                               -print 2x 40%infill
• Amelix GUN.STL                                            -print 1x 20%infill
• Amelix FOOT.STL                                           -print 2x 40%infill
• Amelix TURRET_ring.STL                          -print 1x 20%infill
• Amelix TURRET_ball.STL                          -print 1x 40%infill
• Amelix TURRET.STL                                    -print 1x 20%infill, supports included in the model
• Amelix SOCKET.STL                                    -print 5x 20%infill