Hello everyone! I am the owner of this vacuum cleaner, in fact, I am very pleased and I knowingly made repairs in the apartment for it. But that's not a problem, the rubber shafts are erased, especially cut with long hair, a set of shafts costs 2400r, it's easier for me to buy :) and again, BUT, the app in the phone said "go to the forest - Sevastopol and Crimea are not serviced" of course you can create heaps of VPN, but was not nice !.

Therefore, I rendered this model (posted it here), printed with BiFlex (best filament) vertically with tree support on an old Anet A8 (I have it for experiments with an acrylic dome - like a camera :)) nozzle 250, table 90. The sintering ability turned out to be ideal - do not break :).

Therefore, I spread it to you, both shafts can be printed the same. There is a thought, the rear shaft - which rowes against the current :) - print from nylon

Depending on the shrinkage, X and Y can be increased by a couple of percent.