I present the MK001! This is inspirate to the iconic Tank off the Metal Slug Saga.
This prints is 18 x 20 x 15 (cm) with Full details and moving tracks.
I put a lot of work into this design so it requires no special tools
RC Moving parts:
2 x tracks
1 x turret
1 x Cannon
2 x machine guns
Please note, there are additional materials needed (such as screws nuts, washers and bearings, all listed below).
ON TO THE DETAILS:
SIZE: 18 x 20 x 15 (cm)
PRINTER SIZE: 200mm x200mm x100mm
NUMBER OF PARTS: I'm just going to say 138
ASSEMBLY GUIDE: Manual Poster Included (nice to hang too)
MATERIAL LIST:
Electronics:
2 continuously rotating servos
3 nano-servos
Recommended battery: 2S 7.5V 500mAh
Mechanics:
3 ball bearings 13x4x5mm
230 M3 x10mm screws
3 M3 15mm screws
2 M3 25mm screws
22 Nut M3 3mm
1 M3 58mm screw
1 M4 25 mm
2 M4 45mm
1 M4 10mm washer
1 M4 20mm washer
5 nut M4
1 paperclip
1 x Glue
100 x patience
If you run into problems, comment or message me and I'll see what I can do to help
Thanks for check this out!
Loading prints...
RC Metal Tank MK001
Creative Commons Attribution-NonCommercial
You can distribute, remix, adapt, and build upon the material in any medium or format for noncommercial purposes only, with attribution to the creator.
Licensed under CC BY-NC
Files Included
43 downloadable files:
Loading comments...