
SplashLIGHT | Up-cycle Any Bottle Into a Beautiful Feature Lamp - 3D Printed by Mark Simmons
1345
Printer Used
My Rating
My Thoughts
I printed with a raft, but not supports. I had to run it through Netfabb's model repair as my software detected open vertices. Next print will have to be with supports because the model has some angles that are more than 45°. I'll clean this up and use XTC-3D to make it shine! Great model idea! This is gonna look great on my new kitchen island!
Settings
Print Time
5
hr(s)
58
min(s)
Material Brand
MakerBot
Material Type
PLA
Layer Height
0.2
mm
Print Speed
90.0
mm/s
Extrusion Temperature
220.0
°C
Infill %
20.0
%
Comments