“Some assembly required” definitely applies here. I had no problems printing the mano (hand), corazon (middle finger), meniq (pinky finger), pulgar (thumb), or indice (index finger) #1 and #3 pieces with just a brim added for bed adhesion. The anular (ring finger) pieces needed to be printed on a raft for me, at least, and the indice #2 piece needed supports added (I printed it on a raft, too, but a brim might be enough). I attached each piece to the hand using a tied loop of 1mm elastic cord, much like in the video. The elastic cord needs to be pulled to its maximum stretch length before tying off or else the piece will be loose and flop around. If I print this again, I'll try to get three different colors of elastic cord so that I can string the tip piece through the middle and base pieces, and the middle through the base, and then all three into the hand, while still knowing which pairs of ends match. Also, a hemostat came in really handy while fishing around for the elastic cord, which does not like to be pushed.