
Retraction Calibration Test - 3D Printed by MinnesotaMade

1349
Printer Used
My Rating
My Thoughts
This was a great simple print, I used it to test retraction as well as filament quality. For example, in my image displayed I used this print adjust temperature to detect the quality of filament. ABS typically prints at 220-230C, however low quality ABS will perform well at much lower temperatures as I show with the oozing of these prints. An easy method to debug and verify printer calibration.
Settings
Print Time
0
hr(s)
45
min(s)
Material Brand
WORKS (cheap brand)
Material Type
ABS
Layer Height
0.25
mm
Print Speed
30.0
mm/s
Extrusion Temperature
180-220
°C
Infill %
15.0
%
Comments