This is the very first MakerTron ever printed I'm pretty sure! This version of Remix was printed at about 50% scale to test out the parts. You'll notice that overall the robot looks really good, I just didn't spend very much time cleaning the print up after taking it off the print bed, and you can see aberrations where the supports touched the various parts. I'd recommend printing the legs at 60-70% infill at this scale, since the knees might be a little weak if they are too thin. As for orientation of the printed parts, I printed the head upside down with supports, the arms laying horizontal with supports, the legs upright in standing position with supports and the torso on it's back with supports. I don't think I chose the best orientation for all the parts though, need to experiment a little.