Printer is a Monoprice Maker Select. Each item in the pics took about four hours to print. Nozzle is .5 but I had .4 selected when slicing (oops). The main problems in the prints are banding, a little stringing, and the surface is on the Mystic bubbled up slightly over each of the voids in the infill. These are all problems with my setup, not the files. The bed was heated to 60 degrees C and covered with painter's tape a glue stick. All items were printed with a raft. Interestingly, only with the red prints did I get a little peeling up from the bed at the edges. I don't know if it's something to do with the red filament or that it was the only product with rounded edges.