I wasn't too worried about the visible quality, so I used a low resolution that produced a very textured looking product. So far it works great! The size is perfect for holding credit cards and IDs. I do think the clip will eventually break on me, but that's only because I used PLA, which is relatively rigid and doesn't do quite as well with being flexed, but I could be wrong about that. I also don't know exactly how long it took to print, I just set it going and left for the day and the software I use always overestimates the time it will take, so I can't rely on what it told me. If anyone prints this using the same type of printer I have, you will need to use the wave bonding setting for this to ensure it doesn't detach (there is no heated bed on this type of printer). If you are using another printer you can probably ignore this completely.