Printed on a Creator Bot 3D by 3D Printerworks http://www.3dprinterworks.net/ Once I complete the print this will probably get the 5th star. I've only finished the white, black and silver portions at this point. I'm very impressed with the design and layout of the parts for printing! I anticipate it will take another 4-6hrs to finish printing and assembly. I did grab a handful of pocket change and place it in the main ball before gluing it together. This way the weight of the change will make the model stand upright when on a flat surface. I used a translucent orange filament for BB8's colored parts to have a much truer orange. All the parts fit well just about perfect. The orange circles on his main body had to be shaved ever so slightly on the inside to fit on. After a slight shave, they snapped in place and didn't require any glue to hold them on. I only used supports on the main body to endure the top of the half ball didn't droop while printing. Great design! If I Had duel extrusion capability I would print the white and orange parts together as the angle on some of the orange parts caused a few prints to fail and get a little messy under the overhang. However it was easily cleaned up and did not affect the surface finish.