
Zheng3 Penny Catapult - 3D Printed by Nick

1102
Printer Used
My Rating
My Thoughts
This was a nice easy print that turned out well. The parts fit together properly, and using a little super glue, the build is quite sturdy. The catapult itself works, but not as well as I'd hoped. Even with quite a few elastics, the arm catapult arm is pretty unstable. Either way, a fun little desk toy and good print!
Settings
Print Time
4
hr(s)
23
min(s)
Material Brand
ColorFabb
Material Type
PLA
Layer Height
0.0
mm
Print Speed
50.0
mm/s
Extrusion Temperature
220.0
°C
Infill %
20.0
%
Comments