I printed this design a while ago, it being one of my very first prints on my then recently acquired 3d printer. Went mostly great, I did however have some issues with warping on the pencil display holder since I did not have a heated bed at the time. I solved the warping problem by applying glue stick on the original buildtak sheet on my printer for extra adhesion. Furthermore I had some slight issues with retraction on the pencil pot. My retraction distance were set too far and clogged the nozzle midway through the print when the plastic (probably) hardened in the hot-end. That issue got solved with a shorter retraction distance. If I remember correctly, I printed most of the parts in 0,1mm Z-resolution and the pencil pot in 0,2mm. I also added a couple of sticky feet on the floor of the models so they would not skate around on my desk.