
Fully Assembled Ball Bearing - 3D Printed by Aron Igelström



1167
Printer Used
Ultimaker 2
My Rating
My Thoughts
Printed at 240 degrees using PET+. Print came out alright, but some experimentation with feeder spring tension is needed: mine was tensioned a wee bit too hard which means that the printer became "retraction sensitive" (the amount of times that a segment of the filament can pass the extruder gear before getting "too flat", and the extrusion get inconsistent - is decreased with the spring tension) - hence the small perimeter gaps on the surface of my print.
Settings
Print Time
8
hr(s)
0
min(s)
Material Brand
MadeSolid
Material Type
PET+
Layer Height
0.1
mm
Print Speed
30.0
mm/s
Extrusion Temperature
240.0
°C
Infill %
30.0
%
Comments